Connection broken...

The connection to the receiver has been broken.

The data on this page will not be updated until the connection becomes available again.

Attempting to restore connection...

Not logged in
Log in

Status
Configuration
- Communication
  - Input/Output Selection
  - Output Settings
    - SBF Groups
    - SBF Output
    - SBF Output Once
    - NMEA Output
      - NMEA Output Intervals
      - Customize
    - NMEA Output Once
    - Differential Corrections
      - RTCMv2
      - RTCMv3
      - CMRv2
    - Echo Message
    - Periodic Echo message
  - Input Settings
    - Differential Corrections
      - RTCMv2
      - RTCMv3
      - CMRv2
  - COM Port Settings
  - Network Settings
  - NTRIP Settings
  - Registration
- Navigation
  - Positioning Mode
  - Receiver Operation
    - Tracking and Measurements
      - Multipath
      - Smoothing
    - Masks
    - Position
      - Atmosphere
      - Motion
      - Earth Models
      - Integrity
      - Ambiguities
      - Datum
    - Timing
    - GPIO
  - Receiver Initialization
    - Reset Navigation Filter
  - Receiver Setup
    - Antennas
    - Station Settings
  - Advanced User Settings
    - Channel Allocation
    - Tracking
    - Frontend and Interference Mitigation
      - Frontend Settings
    - PVT
      - Satellite Usage
      - Signal Usage
    - Channel Configuration
- Help
  - Receiver Interface
    - Interface Version
    - Permitted Capabilities
- Logging
  - Remove Internal File
  - Disk Management
  - Internal Logging Settings
  - Internal RINEX Logging
    - RINEX Logging Options
    - RINEX FTP Push Options
- File
  - Copy Configuration
  - Power Mode
    - Shut Down
    - Scheduling
  - User Management
  - Reset Receiver
  - Upgrade Receiver using FTP
Logging
- FTP download
Admin
- Receiver Management
  - Show Configurations
- Receiver Upgrade
  - Upgrade Receiver Using Current Connection
- Expert Console
Help

Unsaved Changes...

You have unsaved changes on the page.

Are you sure you want to leave the page and discard the changes?

Set Periodic Echo

	COM1	COM2	COM3	COM4
Message
Interval

Save current configuration to boot configuration.

Receiver	Position	System	Status DiffCorr Connected Overall Quality
Marker:	Mode:	CPU: %
IP Address:	System:	Uptime:
Serial Number:	Info:	Logging: